Condition | new |
---|---|
Asin | B08QW6Y154 |
Category | Electronics |
Subcategory | Fish Finders & Depth Finders |
Leafcategory | CE |
Origin | USA |
Brandname | Venterior |
Height | 1 |
Length | 1 |
Width | 1 |
Weight | 2 |
Display Size | 4.6 centimeters |
Display Type | LCD |
Specification :
1. Measure Units: Meters / Feet
2. Display: TN/Anti-UV LCD display
3. Backlighting: LED
4. 4.6cm diameter Round transducer sensor
5. Depth Range : Max: 100m (328ft) ; Min: 0.9m (3ft)
6. Sensor Beam Angle: 45 degrees
7. Operating Temperature: -14°F to 122°F(-10°C-50°C) .
8. Uses 4 x AAA batteries (not included)
How to use the Sonar Sensor:
1. Toss the sensor and float into the water.
2. Attach the Side-Scan Adapter to the boat hull using the mounting tabs.
3. Attach the sensor to a handle, lower the sensor into the water.
Attention:
1. It will turn off automatically if the depth display reads "---" continuously for 5 minutes.
2. It can not be used to detect bait fish or fish that is smaller than 10cm.
3. When use this fish finder on moving boat, please make sure the bottom of the transducer is horizontal and the moving speed is slowly (lower than 5 mph).
3. Strong waves, suspended matter and muddy water,will affect the performance.
4. Its reading might be interfered with other high power sonar fish finder close to your fish finder. Please make sure there is no other sonar fish finder cloes to your fish finder.
Specification :
1. Measure Units: Meters / Feet
2. Display: TN/Anti-UV LCD display
3. Backlighting: LED
4. 4.6cm diameter Round transducer sensor
5. Depth Range : Max: 100m (328ft) ; Min: 0.9m (3ft)
6. Sensor Beam Angle: 45 degrees
7. Operating Temperature: -14°F to 122°F(-10°C-50°C) .
8. Uses 4 x AAA batteries (not included)
How to use the Sonar Sensor:
1. Toss the sensor and float into the water.
2. Attach the Side-Scan Adapter to the boat hull using the mounting tabs.
3. Attach the sensor to a handle, lower the sensor into the water.
Attention:
1. It will turn off automatically if the depth display reads "---" continuously for 5 minutes.
2. It can not be used to detect bait fish or fish that is smaller than 10cm.
3. When use this fish finder on moving boat, please make sure the bottom of the transducer is horizontal and the moving speed is slowly (lower than 5 mph).
3. Strong waves, suspended matter and muddy water,will affect the performance.
4. Its reading might be interfered with other high power sonar fish finder close to your fish finder. Please make sure there is no other sonar fish finder cloes to your fish finder.